HELP! MY POLE'S STUCK

[Zoki@Serbia]

It's an old thread but I think this is worth it.If you get your pole sections locked,maybe the best and most gentle solution to get them apart is to worm up one section until it expands enough,not over the open flame offcourse,just find some heat source without flame,and then wait until you think it's hot enough and then turn and pull at the same time!

Since carbon is cooked for about an hour and 1/2 set on 125-130 degrees Celsius while the rod is being made in the first place,you'll hardly get it that worm to start melting the epoxy betwen layers so no need to fear any heat damage untill it's only hot enogh to hold without pain,any wormer and I can't guarantee anything!?

Pozdrav from Serbia

Zoki