Legering Set up (help)

[Andrew Burgess 12]

leedsunited:

Can i just drill a hole through a bead

 

I aint got no rubber beads i got plastic

plastic beads will do

[Andrew Burgess 12]

leedsunited:

So what should i use for a hooklength

 

All i got is hooks to nylon and braided hooklengths with swivels on but they have a higher breaking strain than the line

Get the hook to nylon one forget the ones with the braided hooklenght

[rickster 0]

leeds keep it simple,dont start trying to adapt anything, any bead will do for aslong as the hole in the middle stops at the swivel. Its only to stop the ledger going over the swivel and to take out the impact of the cast.

Just keep it as

 

Slide the ledger on your reel line then the bead, attach the swivel and hookline to the end of it, lift the rig up and you will see the weight slides up and down the reel line without passing the swivel

[Peter Waller 50]

Personally I think plastic beads are fine. And I really wouldn't worry too much about rubber beads. Just keep it simple!

 

Personally I think too many people just complicate the issue. Not least the manufacturers, such as Fox, who simply want you to buy loads of unnescessary junk to adorn your ledger rigs with!

[Andrew Burgess 12]

Leeds, just do this very simple rig. Just follow the diagram which will do on all sort of legering

 

 

[Peter Waller 50]

Spot on Andrew! Good advice there Leeds.

[Andrew Burgess 12]

Thank you Peter

[Dick Dastardly 88]

Where do I get the ledger"strips" from?

[leedsunited 0]

Whats a leger strip ?

 

And do i use a hook to nylon ?

 

Also i have no kooklengths with swivels (that have a lower bs than my line)

 

Thank you !

[Andrew Burgess 12]

BUDGIE:

Where do I get the ledger"strips" from?      

sorry should been leger stop. let me do that one again in the right daigram

 

[ 30. October 2004, 08:53 PM: Message edited by: Andrew Burgess ]